This project was not one I have been dreaming of doing…it was done purely out of necessity! That said, it is nice that when I need something boring like a peg bag, I have the skills to make it – and make it look good – rather than have to go and buy it.
How great is the strawberry print? My old peg bag was looking very sad, hanging by a thread and ready to fall apart with the next gust of wind.
So I decided I would make one, and the design is very simple but I had to think a little bit about the materials. My peg bag lives permanently on the line outside so it is subject to all weather conditions. In Melbourne throughout the year it ranges from 0 – 45 degrees celcius, and we get a fair bit of rain. It appeared that the area of the calico peg bag that wore out was the part around the top that came in contact with the wire so I needed something sturdier for the bag top.
Oilcloth was my choice, but I knew that the water would just pool inside it when it rained, so I decided to add a strip of calico to the bottom of the bag for the water to soak into and drain out or evaporate.
If you plan to keep your peg bag indoors, you can omit adding the calico.
Here is how I made it-
two pieces of oilcloth, 22 x 30cm (8.5 x 12″)
one piece of calico (or a cotton scrap), 14 x 24cm (5.5 x 9.5″)
two wire coat hangers OR sturdy but pliable wire from a hardware store
sewing supplies and a denim needle (100/16)
Fold the calico strip in half length ways. With right sides together (the calico doesn’t have a right side but the oilcloth will) sew to the short ends of the oilcloth. This forms the base of the peg bag. Oilcloth is quite a thick material and requires a sturdy needle, so I use a denim needle in my machine. It also requires firm guidance through the machine while stitching.
Fold the other short oilcloth edges over about 2.5cm (1″) to form a casing for the wire.
Stitch in place. I stitched them twice to make them extra secure.
With right sides together, stitch the sides of the bag up, but stop at the casing stitching. You need to leave the casings open for the wire to run through.
Turn it out and put it aside. Don’t worry if the oilcloth appears creased. Oilcloth relaxes when it warms up and the creases come out naturally.
Next, take your coat hanger and cut it. You need most of the length, so just snip the hanger part off.
Now for the slightly tricky part – thread the wire through one side of the casing, then gently bend and manipulate it to thread through the other side.
Threading the wire through the second side took me a good 10-15 minutes, just to bend it gently and gain the rounded shape that I wanted for the top of the bag.
Snip off any excess wire and tuck the wire ends into the casing so they can’t pop out. It doesn’t have to be perfect, mine looked a bit like a dog’s breakfast.
To finish, I used the existing wire hanging hook on my old peg bag and attached it to my new one. To create a hook, you can use the second coat hanger and snip of the base. Create loops around the bottom of the arms of the hanger and attach them to the wire that is visible between the casing of the bag.
Done! While dealing with the drudgery of laundry, we might as well have good looking accessories!
Oilcloth is a great material to sew with and really practical, especially for items or garments that can be wiped clean – place mats, table cloths, baby bibs, baby change mats. I have also used oilcloth to make some toiletries bags – you can see the tutorial here. You can buy oilcloth in the home dec area of the fabric store, or there is a wide range available online.